Shop CTC Security for best deals on
Features
Power Off the Panel
Disconnect both AC power and the battery from the alarm control panel.
Locate the Serial Port
Open the panel enclosure and locate the “Serial Port” (also known as the Direct Link Port).
Connect the CM255B
Plug the CM255B module into the serial port. Ensure it is correctly aligned (refer to panel diagram if unsure).
Power On the Panel
Reconnect AC power first, then battery.
Observe the LED Indicator
Green LED only: Key is valid and ready to use.
Red LED only: Key has already been used — discard.
Alternating Red & Green flash: Factory default in progress.
Remove the Key
Once LEDs are flashing alternately, the reset is complete. Remove and discard the CM255B — it cannot be reused.
Default Installer Code & MyAlarm Setup
After using the key, the installer code will reset to 1234
.
This will allow you to access the menu and perform setup tasks, including:
Go to Menu 509
Enter the 11-digit Installer ID
Register the panel to the MyAlarm platform for remote access and management.
Not compatible with 880, 862 or older series, Solution 2000, Solution 3000
Installation Guides
For all orders exceeding a value of 100USD shipping is offered for free.
Returns will be accepted for up to 10 days of Customer’s receipt or tracking number on unworn items. You, as a Customer, are obliged to inform us via email before you return the item.
Otherwise, standard shipping charges apply. Check out our delivery Terms & Conditions for more details.